As energy costs increase, people begin to look for ways to lower their personal energy consumption. One of the popular points of improvement are new windows. With advances in technology and materials, windows are substantially better than their predecessors at retaining heat during winter months and keeping the home cooler during the summer. Unfortunately, new windows can be quite expensive! However, there are options if you are unable to afford new windows or would prefer to replace your windows gradually rather than all at once.
Before embarking on the improvement of your current windows, it pays to inspect them. Are there rotten boards, cracked glass or other broken parts? Depending on the condition you might be forced to replace these windows as they are beyond enhancement. Also, consider replacement if your windows were installed before 1978 as they might contain lead paint. Lead is an hazardous substance that should not be in your home particularly if children are present.
If your windows pass muster, you can begin improving them for energy efficiency. One of the cheapest and easiest tasks is to caulk all cracks and gaps around the window frame. Air can seep (and sometimes actually blow) through these gaps. By blocking these pathways you will be taking a big leap toward increased energy efficiency. You will need a caulk gun which will run less than $10 and is very easy to operate even for a complete novice. You will also need a few tubes of caulk which run a few dollars per tube at home improvement stores. Be sure to purchase paintable caulk if you would like to cover the caulk after it has cured.
Actually applying the caulk is very easy. Simply load the caulk tube into the gun, trim off the end of the tube with scissors or a knife and then run a wire down the tip to puncture the foil covering inside. Apply the tip of the tube to the area you wish to seal and slowly pull the trigger. It might takes a few squeezes for the caulk to come out on a new tube. Once it is slowly flowing, move the tip over the crack to fill it up. To smooth the caulk or push it into a new position, wet your finger and apply pressure as needed. Using a dry finger causes the caulk to stick to your finger and tends to make things messier. In a pinch, saliva works just as well!
Also, be sure to pick up weather stripping to fill in gaps around the sash where the window goes up and down. You will need to custom fit the stripping to your windows.
Be sure to inspect your caulk and weather stripping every year to make sure everything is still in working order.
By taking these two simple steps, you have gone a long way toward greater efficiency. Plus, you have save thousands of dollars in the process! That will make anybody feel good.
For more information on your HVAC units, service, & repair or energy efficiency, please visit http://www.AbelOnSite.com.
Article independently authored by Eric Parish. The content herein may or may not reflect the views and opinions of Abel On Site.
No comments:
Post a Comment